您現在的位置:首頁>>快速門新聞 >> 「綿陽堆積門」快速門電控系統連接時注意問題

                                  「綿陽堆積門」快速門電控系統連接時注意問題

                                  作者:綿陽快速門批發   發布時間: 2019/7/1 14:54:58



                                  「綿陽堆積門」快速門電控系統連接時注意問題

                                  Attention Problems in Connecting Electronic Control System of "Mianyang Accumulated Gate" Fast Gate


                                   

                                  快速門電控系統連接時注意問題


                                  Attention Problems in Connecting Electronic Control System of Fast Gate
                                   

                                  1、當需要對控制系統進行打開、連接、保養或者檢查的時候,需要將主電路電源切斷。


                                  1. When the control system needs to be opened, connected, maintained or checked, the power supply of the main circuit needs to be cut off.
                                   

                                  2、主電源切斷后,控制系統在5分鐘內也有帶電,內部電容會有一個延遲存電。


                                  2. After the main power supply is cut off, the control system will also be charged within 5 minutes, and the internal capacitance will have a delayed storage.

                                   

                                  綿陽廠房快速堆積門安裝


                                  3、因存在電流的可能,禁止在此時代觸摸電子元件,以免發現意外事故。


                                  3. Because of the possibility of electric current, it is forbidden to touch electronic components in this era in order to avoid accidents.

                                  4、實現接線后,在進行第一次運行的時候,必須對控制箱的接線和電機的接線進行細致的檢查。尤其電機等部件是否連接正確,否則可能對變頻器造成不可修復的損壞。


                                  4. After wiring, the wiring of control box and motor must be carefully checked during the first operation.Especially if the motor and other components are connected correctly, otherwise it may cause irreparable damage to the frequency converter.
                                   

                                  5、所有從控制電源至控制系統的電源絕緣必須良好,推薦應用大于230V的檢測設備對電源的絕緣層進行檢測。


                                  5. All the power supply insulation from the control power supply to the control system must be good. It is recommended that the insulation layer of the power supply be tested by the testing equipment larger than 230V.

                                   

                                   

                                  成都快速門控制方式

                                  6、根據EMC指令,電機電纜可以應用帶屏蔽層的電纜。屏蔽必須在兩端接地相連。該屏蔽層不可有任何電壓。


                                  6. According to EMC instructions, motor cables can be used with shielded cables. Shielding must be grounded at both ends. The shielding layer must not have any voltage.

                                  7、快速門由于存在告訴運動而使門簾之間摩擦,在摩擦的過程中可能帶有大批靜電,如果不及時釋放,可能回導致控制單元損壞。以是需要做放靜電的相關保護措施。
                                   

                                   7. The friction between the curtains is caused by the telling motion of the fast door. There may be a lot of static electricity in the process of friction. If it is not released in time, it may lead to the damage of the control unit. Therefore, it is necessary to take some protective measures for electrostatic discharge.


                                  「綿陽堆積門」快速門電控系統連接時注意問題

                                  Attention Problems in Connecting Electronic Control System of "Mianyang Accumulated Gate" Fast Gate


                                  聯系我們CONTACT US
                                  版權所有:成都龍盛門業有限公司
                                  電話:18624318220
                                  聯系人:童經理
                                  網址:http://www.apintsizedlife.com
                                  查看更多
                                  電話:18624318220(媒體勿擾)    聯系人:童經理
                                  版權所有:成都龍盛門業有限公司
                                  百度地圖 - 網站地圖 -
                                  A篇片在线观看视频